Back: Preliminaries
Forward: Writing A Cygwin Friendly Package
 
FastBack: Writing A Cygwin Friendly Package
Up: Integration with Cygnus Cygwin
FastForward: Cross Compilation
Top: Autoconf, Automake, and Libtool
Contents: Table of Contents
Index: Index
About: About this document

25.2 Installing GNU Autotools on Cygwin

With all of the above infrastructure in place, each of the GNU Autotools can be built natively and installed from source right out of the box. It is worth taking care with the installation directories, as there is no package management under Cygwin, and it is easy to let everything get thrown into a big pile in `/usr/local', which makes it relatively difficult to upgrade and remove packages.

Support for Cygwin has been in Autoconf for several years, as far back as version 2.0 as best as I can tell. Building it has never been a problem as long as GNU M4 and a Bourne Shell are available, it is the macros themselves which offer this support. Of course, any Autoconf macros you write yourself must be designed carefully to not make any assumptions about being executed on Unix if the Cygwin compatibility is to remain. A binary package of Autoconf for Cygwin version 1.1.1 is available from the CygUtils website(62).

Automake joined the fray much later than the Cygwin support code was added to Autoconf, and has consequently always supported Cygwin. Until the last release of Cygwin, the stumbling block has always been finding (or building) a Cygwin compatible Perl interpreter for Automake to use. Thanks to the work of Eric Fifer, Perl 5.6.0 builds right out of the box on Cygwin, removing this problem entirely. Ready built packages of Perl and Automake are available from the CygUtils website.

The initial Libtool support for Windows was written by Ian Lance Taylor of Cygnus Solutions, when Cygwin was at release b18, See section Microsoft Windows. More recent releases of Cygwin in general, and GCC in particular have much better facilities for building and linking with Windows DLLs, to the extent that with a little perseverance it is possible to build DLLs with GCC from C++ sources, and to have those DLLs interoperate with DLLs built with Windows development environments. In time, automation of these facilities will make their way into Libtool. The method that Libtool currently uses to build DLLs works with Cygwin releases at least as far back as b18, and at least as far forward as the Autoconf, Automake, and Libtool: Installing GNU Autotools on Cygwin