From the main menu, choose "Create" and tap enter.
Main Menu
Create Create a connection enter |
Leave the provider name as "provider" in the next
screen. You only need to change this if you are using more
than one ISP. The "provider" stting is used by default when
your modem dials. If you enter a different name here, you will
have to specify it when you invoke the dial-up command.
Provider Name
provider enter |
If your ISP connection
uses server assigned name server addresses, choose "Dynamic"
and skip to next section.
Configure Nameservers (DNS)
(*) Dynamic Use dynamic DNS enter |
If your ISP connection specifies name server addresses,
choose "Static" and enter the addresses.
Configure Nameservers (DNS)
(*) Static Use static DNS enter
IP number
Enter the IP number for your primary nameserver.
nnn.nnn.nnn.nnn enter
IP number
Enter the IP number for your secondary nameserver (if any).
nnn.nnn.nnn.nnn enter |
It is
likely that your ISP has designed its service for MS Windows
clients. In that case, the "PAP" protocol will work.
Authentication Method for provider
PAP Peer Authentication Protocol enter |
The user name is
the name of your account with your ISP. Delete the message
"replace_with_your_login_name" and enter your user
name. Then enter your password.
User Name
Enter the username given to you by your ISP.
username enter
Password
Enter the password your ISP gave you.
******* enter |
Set the
modem port speed to its highest value (115200). Choose pulse
or tone dialling, and enter the telephone number of your ISP
connection.
Speed
115200 enter
Pulse or Tone
(*)Tone tab enter
OR
Pulse or Tone
(*)Pulse tab enter
Phone number
nnn |