hfx.py is meant to be a full-featured Long Wave / Medium Wave
and Short Wave (250kHz to 30Mhz) AM and Single Sideband receiver.
It uses the USRP with a Basic RX board, and will need an
antenna and some preamps, about 30db gain will work. See the
'Help' menu or hfx_help for more info.

----------------------------------------------------------

Powermate knob supported but not required, tooltip frequency display,
single click tuning, AGC, record to disk, play from disk and record
audio.  Ability to tailor the audio passband with two sliders over the
spectrum display. The sliders almost align with the actual
frequency. Preset filter settings for LSB (-3000 to 0kHz), USB (0 to
+3000kHz), CW (-400 to -800Hz) and AM (-5kHz from carrier to +5kHz).

AM now switches in a synchronous PLL detector ), USB (0 to
+3000kHz), CW (-400 to -800Hz) and AM (-5kHz from carrier to +5kHz).

AM now switches in a synchronous PLL detector ), USB (0 to
+3000kHz), CW (-400 to -800Hz) and AM (-5kHz from carrier to +5kHz).

AM now switches in a synchronous PLL detector ), USB (0 to
+3000kHz), CW (-400 to -800Hz) and AM (-5kHz from carrier to +5kHz).

AM now switches in a synchronous PLL detector ), USB (0 to
+3000kHz), CW (-400 to -800Hz) and AM (-5kHz from carrier to +5kHz).

AM now switches in a synchronous PLL detector ), USB (0 to
+3000kHz), CW (-400 to -800Hz) and AM (-5kHz from carrier to +5kHz).

AM now switches in a synchronous PLL detector ), USB (0 to
+3000kHz), CW (-400 to -800Hz) and AM (-5kHz from carrier to +5kHz).

AM now switches in a synchronous PLL detector ), USB (0 to
+3000kHz), CW (-400 to -800Hz) and AM (-5kHz from carrier to +5kHz).

AM now switches in a synchronous PLL detector ), USB (0 to
+3000kHz), CW (-400 to -800Hz) and AM (-5kHz from carrier to +5kHz).

AM now switches in a synchronous PLL detector ), USB (0 to
+3000kHz), CW (-400 to -800Hz) and AM (-5kHz from carrier to +5kHz).

AM now switches in a synchronous PLL detector ), USB (0 to
+3000kHz), CW (-400 to -800Hz) and AM (-5kHz from c